Packet data access points
Press
, and select
Tools
>
Settings
>
Connection
>
Destinations
>
New access point
,
and follow the instructions on the screen. Or, open one
158
Se
ttings
of the access point groups, select an access point
marked with , and select
Edit
.
Follow the instructions from your service provider.
Select from the following:
●
Access point name
— You obtain the access point
name from your service provider.
●
User name
— The user name may be needed to
make a data connection, and is usually provided by
the service provider.
●
Prompt password
— If you must enter the
password every time you log in to a server, or if you
do not want to save your password in the device,
select
Yes
.
●
Password
— A password may be needed to make
a data connection and is usually provided by the
service provider.
●
Authentication
— Select
Secure
to always send
your password encrypted or
Normal
to send your
password encrypted when possible.
●
Homepage
— Depending on the access point you
are setting up, enter the web address or the address
of the multimedia message centre.
Select
Options
>
Advanced settings
and from the
following:
●
Network type
— Select the internet protocol type
to transfer data to and from your device. The other
settings depend on the selected network type.
●
Phone IP address
(for IPv4 only) — Enter the IP
address of your device.
●
DNS addresses
— Enter the IP addresses of the
primary and secondary DNS servers, if required by
your service provider. To obtain these addresses,
contact your internet service provider.
●
Proxy server address
— Enter the address of the
proxy server.
●
Proxy port number
— Enter the port number of
the proxy server.